|
Carpet Cleaner
Carpet Cleaner (# 20-105-07 and 20-105-08)
Engine Type: Electric
Operation Instruction: Plug machine into outlet. Lift top cover and add water. Pour soap into the water before or after filling. While moving forward, press button on handle to dispense fluid. To vacuum fluid, release button while moving backwards with the machine level. Empty dirty water once full.
View Details
|
FA20-105 |
Carpet Cleaner |
. |
38.00 |
/ DA |
PER DAY |
|
|
Carpet / Upholstery Attachments
Carpet / Upholstery Attachments (# 20-120-06)
Additional Parts/Information: For use with the Hot Water Carpet Cleaner. See Hot Water Carpet Cleaner for further instructions.
View Details
|
FA20-106 |
Carpet / Upholstery Attachments |
. |
10.00 |
/ DA |
PER DAY |
|
|
Carpet Cleaner - Hot Water
Hot Water Carpet Cleaner (# 20-112-02)
Engine Type: Electric
Safety Protection: Can get extremely hot; use with caution. Operation Instruction: Connect vacuum hose to the hose connector on extractor and to the end of the vacuum tube on the floor tube. Connect solution hose to extractor. Fasten quick disconnect fitting. Place hot water in tank. Add cleaning chemical (for correct amount follow directions on unit.) Plug right cord in. Activate pump and set switch for the upholstery setting. Run pump until fully primed, then turn pump off. Remove the priming hose and attach the cleaning hose/tools. Plug in the left heat cord. Wait 2 minutes and begin to clean as desired. Once finished, pull out T-handle and drain dirty water.
Additional Parts/Information: Use liquid not powder chemicals, as it can damage machine. Plug each cord into a separate outlet as it may blow a fuse. Buttons on machine are as follows- from left to right standing behind. Heat-Pump-Vac.
View Details
|
FA20-112 |
Carpet Cleaner - Hot Water |
. |
50.00 |
/ DA |
PER DAY |
|
|
Carpet Dryer / Blower
Carpet Dryer / Blower (# 20-120-08)
Engine Type: Electric
Safety Protection: N/A.
Operation Instruction: Plug unit in and select desired speed. Additional Parts/Information: N/A.
View Details
|
FA20-120 |
Carpet Dryer / Blower |
. |
25.00 |
/ DA |
PER DAY |
|
|
Floor Polisher 13" 1/2 Hp
13" 1/2hp Floor Polisher (# 20-125-03)
Engine Type: Electric
Operation Instruction: Plug power cord into outlet. Adjust to desired height. Hold safety switch under right lever. While still holding the safety switch, squeeze levers under handle to activate machine.
Additional Parts/Information: Extension cord needed. 13" Floor scrubbing brush. Pads sold separately.
View Details
|
FA20-125 |
Floor Polisher 13" 1/2 Hp |
. |
35.00 |
/ DA |
PER DAY |
|
|
Floor Polisher Drive Plate 17"
17" Floor Polisher Drive Plate (# 20-127-00)
Additional Parts/Information: For use with 17" 1.5hp Floor Polisher. See 17" 1.5hp Floor Polisher for further instructions.
View Details
|
FA20-127 |
Floor Polisher Drive Plate 17" |
. |
15.00 |
/ DA |
PER DAY |
|
|
Floor Polisher Carbide Abrasive
17" Carbide Abrasive Floor Polisher (# 20-128-00)
Additional Parts/Information: For use with 17" 1.5hp Floor Polisher. See 17" 1.5hp Floor Polisher for further instructions.
View Details
|
FA20-128 |
Floor Polisher Carbide Abrasive |
. |
28.00 |
/ DA |
PER DAY |
|
|
Floor Polisher 17" 1.5 Hp
17" 1.5hp Floor Polisher (# 20-130-04)
Engine Type: Electric
Safety Protection: N/A.
Operation Instruction: Plug power cord into outlet. Adjust to desired height. Hold safety switch under right lever. While still holding the safety switch, squeeze levers under handle to activate machine.
Additional Parts/Information: Extension cord needed. 17" Floor scrubbing brush. Pads sold separately.
View Details
|
FA20-130 |
Floor Polisher 17" 1.5 Hp |
. |
42.00 |
/ DA |
PER DAY |
|
|
Floor Sander - Drum ( Sl8 )
Drum Floor Sander (# 20-135-03)
Engine Type: Electric
Safety Protection: N/A.
Operation Instruction: Plug in unit to power outlet. Take sandpaper (sold separately) and put one end into the front hole. Place the other end of the sandpaper and place it in the rear hole. Tighten the sandpaper with the side knob on the left of the unit. Turn the power switch on and sand down to desired thickness.
Additional Parts/Information: SL8#20, SL8#36, SL8#80 sandpaper sold separately.
View Details
|
FA20-135 |
Floor Sander - Drum ( Sl8 ) |
. |
55.00 |
/ DA |
PER DAY |
|
|
Floor Sander - Edger ( Sl7 )
Edger Floor Sander (# 20-140-03)
Engine Type: Electric
Safety Protection: N/A.
Operation Instruction: Plug in unit to power outlet. Take sandpaper (sold separately) and put on sander wheel. Make sure bag is emptied and placed on sander. Hold hands on right and left handle while sanding and edging as desired.
Additional Parts/Information: Sandpaper/edger paper sold separately.
View Details
|
FA20-140 |
Floor Sander - Edger ( Sl7 ) |
. |
35.00 |
/ DA |
PER DAY |
|
|
Floor Sander - Orbital
Orbital Floor Sander (# 20-150-04 and 20-150-05)
Engine Type: Electric
Safety Protection: N/A.
Operation Instruction: This is a four sanding pad unit. Place sanding pads on machine bottom. Plug machine into outlet. Turn on power switch. Additional Parts/Information: Sand paper sold separately.
View Details
|
FA20-150 |
Floor Sander - Orbital |
. |
48.00 |
/ DA |
PER DAY |
|
|
Floor Sander , U-sand Orbital
Orbital Floor Sander (# 20-152-01 and 20-152-02)
Engine Type: Electric
Safety Protection: N/A.
Operation Instruction: Place sandpaper (sold separately) on the bottom of the unit. Plug in power cord to outlet. Turb nob on handle into comfortable position. Turn switch under handle into the on position. Sand as necessary. Empty bag after use.
Additional Parts/Information: Uses U-600k, U-624, U-636, U-650, U-680, U-6120 sandpaper sold separately.
View Details
|
FA20-152 |
Floor Sander , U-sand Orbital |
. |
68.00 |
/ DA |
PER DAY |
|
|
Floor Stripper - Electric
Orbital Floor Sander (# 20-160-03)
Engine Type: Electric
Safety Protection: Safety Glasses, Gloves, Ear Protection, Steel Toe Boots (optional.)
Operation Instruction: Make sure power switch is in the off position. Plug in the power cord to the outlet. Adjust handle bars and wheels if/as necessary. Turn power switch on.
Additional Parts/Information: Switch must be turned off before connecting to power.
View Details
|
FA20-160 |
Floor Stripper - Electric |
. |
60.00 |
/ DA |
PER DAY |
|
|
Wet Dry Vacuum - Dry Use Only
Wet / Dry Vacuum (# 20-170-04)
Engine Type: Electric
Safety Protection: N/A.
Operation Instruction: Plug device into wall. Add attachments as needed. Empty vacuum dirt storage when full.
Additional Parts/Information: Hose and head attachments.
View Details
|
FA20-170 |
Wet Dry Vacuum - Dry Use Only |
. |
28.00 |
/ DA |
PER DAY |
|
|
Wet / Dry Vacuum - Wet Use Only
STIHL SE 122 7.9-gallon Wet Vac
The STIHL SE 122 features a quiet, powerful motor - operating at only 62 dB(A) with 11% less noise than the SE 61. Plus, with 27% better suction and its larger 7.9 gallon capacity canister, the SE 122 can handle just about anything your jobsite can throw at it. Three cleanup tools - a universal tool, crevice tool and adjustable floor tool - are easily stored on a self-contained tool keeper so they're always at hand when you need them. It also features a 10' suction hose and 25' electrical cord, so you can out-maneuver your mess with ease. When work gets messy, this vac picks up just about anything, including the slack.
Power Source: Electric, 120v
Weight: 22 lbs
Container capacity: 7.9 gallons
View Details
|
FA20-171 |
Wet / Dry Vacuum - Wet Use Only |
| 28.00 |
/ DA |
PER DAY |
|
